The Industry Leader in OEM Style and Aftermarket Spoilers
Painted Custom Style Rear Spoiler
Fits: 2007-09 Hyundai Santa Fe
Part # WD5126U
ATTENTION: Buyer must supply paint code. Please email this information to tony@zigsauto.com. If you have any problems finding your paint code please feel free to call Tony at 877-325-9345. Our spoilers are made of the highest quality materials, guaranteed not to crack, fade, or warp. All of our spoilers are guaranteed to fit perfect & come painted to match your vehicle. They come with all the hardware for easy installation.
INSTALLATION
HARDWARE:
Drill
1/8" Drill Bit
5/16" Drill Bit
Hex Head or Philips Screwdriver
Masking Tape
Rust Proof Paint
TOOLS REQUIRED:
Rear Spoiler
Brake Light (if applicable)
Gaskets
M6 x 16mm Steel Screws
Washers
Drill Locator Strips
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
NOTE: Always pre-fit the spoiler to the vehicle to make sure that it is the proper model for the application before painting, drilling or cutting. Improper Installation may void your warranty. Parts Which have been painted, modified or prepped can't be returned.
1. Prepare and clean the trunk lid for working.
2. Insert Locator Strips provided in hardware kit into mounting holes. Use small piece of masking tape to secure locator strips to spoiler.
3. Carefully position the spoiler and find the most suitable location.
4. Tape down the Locator Strips and carefully remove the spoiler leaving the Locator Strips taped to the trunk. Then drill holes through the center of the Locator Strips using 1/8" Drill Bit.
5. Remove Locator Strips and drill through the 1/8" drill hole using 5/16" Drill Bit. If spoiler equipped with Brake Light, locate and drill a hole for the wire.
6. Treat all the bare steel with Rust Proof Paint.
7. (If Brake Light required) Feed the Brake Light wire through the channel and install the Brake Light using screws or double sided tape.
8. Install Gaskets provided.
9. Screw the spoiler in place using the screws and washers provided in the hardware kit. Tighten All screws by hand. Avoid over-tightening.
10. (If Brake Light required) Hook-up the Brake Light Wire to the third brake light.
11. At the end clean out the trunk lid thoroughly, make sure to remove all metal shavings.
